About kmwalsh

kmwalsh · 07-01-2002

I attended the EIGRP Troubleshooting session in San Diego, and learned a lot - nice job.After looking at our network here, and trying to apply some of the principles discussed regarding meshiness, I now have a quick question.What makes an EIGRP query...

kmwalsh · 07-17-2002

Also ... Check to see if you have Daylight Savings Time configured .. NTP is generically defined in UTC. Your local configuration will display this time anyway you like ...Good Luck

kmwalsh · 07-01-2002

Thanks Don ...After attending the session, I realized that we needed to reduce the scope for EIGRP by setting most of the shared VLAN's to be passive.My fear is that this mesh might cause an exponential explosion of messaging. Router B gets a query f...

kmwalsh · 10-26-2001

The most obvious method is to do a 'show interface ser 0/0' on your 2610 router, or whichever interface your T-1 is attached to. This will show the current 5 minute average loading on the interface. You can also change the load-interval to something...

Member Since	‎10-26-2001 05:11 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	4

User Statistics

User Activity

EIGRP Meshiness

Re: NTP time difference

Re: EIGRP Meshiness

Re: Measuring Bandwidth Utilization