About angristan

angristan · 06-01-2019

Hello everyone! I need help to set up my IPSec VPN. Here is my topology in GNS3: I'm trying to setup a VPN between ffw.par.rt01 and each of the other router (mar,lim,nan). Meaning every VPCS can access the ffw.par.* VPCS via the VPN, and the ffw.par...

angristan · 05-11-2019

Hello, Here is my topology: I have dynamic NAT on ffw.lim.rt01.VLAN 10's gateway is 10.0.1.1 on ffw.lim.rt01's g0/1.10. VLAN 20's gateway is 10.0.1.17 on ffw.lim.rt01's g0/1.20.Each VPCS can ping each other.VPCS can ping 72.145.30.1 thanks to NAT. I ...

angristan · 06-06-2019

OK, I figured it out:I applied the crypto map on g0/1 on ffw.mar.rt01 instead of g0/0.It's working now!

angristan · 06-06-2019

The VPN seems down:ffw.par.rt01#show crypto sessionCrypto session current statusInterface: GigabitEthernet0/0Session status: DOWNPeer: 72.145.30.14 port 500IPSEC FLOW: permit ip 10.0.2.0/255.255.255.0 10.0.0.0/255.255.255.0Active SAs: 0, origin: cryp...

angristan · 06-06-2019

Hello!Does anyone have an idea?Thanks

angristan · 06-03-2019

Here is my current config: ffw.par.rt01 crypto isakmp policy 5 encr 3des authentication pre-share group 2 crypto isakmp key cisco@123 address 72.145.30.14 ! ! crypto ipsec transform-set MY-SET esp-aes esp-md5-hmac mode tunnel ! ! ! crypto map IPS...

angristan · 06-02-2019

First of all, thank you for your answer. Here is my config after setting up the VPN + applying your suggested changes (which apparently did not help): ffw.par.rt01#sh running-config Building configuration... Current configuration : 4795 bytes ! ! La...

Member Since	‎05-11-2019 01:15 PM
Date Last Visited	‎02-07-2022 12:10 AM
Posts	10

User Statistics

User Activity

Setting up site to site IPSec VPN

Restrict inter-VLAN routing

Re: Setting up site to site IPSec VPN

Re: Setting up site to site IPSec VPN

Re: Setting up site to site IPSec VPN

Re: Setting up site to site IPSec VPN

Re: Setting up site to site IPSec VPN