Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have connected a modem on switch port 23 and below config is the config on router subinterface and switch port.This is not working. I can't ping the next hop x.x.x.97. This was working when modem was connected directly to the router.Any suggestions...
Below is the current config and when we login with our id, it directly goes to privilege mode(router #). We are now planning to add enable secret. Will it work with current config or any other changes are required for it to work with TACACS? aaa auth...
See below .. Hope this helps in understanding the scenario - Router gi0/0 - connected to switch on Gi0/1Switch Fa0/23 - connected to Modem. Config on router -- interface GigabitEthernet0/0Description - SW1no ip addressload-interval 30duplex fullspeed...
Hi Paul, I am creating sub-interface because there is no free port on router.And yes I am pinging using vrf.See below .. Hope this helps in understanding the scenario - Router gi0/0 - connected to switch on Gi0/1Switch Fa0/23 - connected to Modem. Co...
Router gi0/0 - connected to switch on Gi0/1Switch Fa0/23 - connected to Modem. Config on router -- interface GigabitEthernet0/0Description - SW1no ip addressload-interval 30duplex fullspeed 1000end interface GigabitEthernet0/0.2description Data VLANe...
Below is the config on router which was working. After moving modem to switch, I created a subinterface with 110 vlan, created L2 vlan 110 on switch and configured switch port connected to modem as access port for vlan 110. interface GigabitEthernet0...
Yes. Router is connected on Gi0/1 of switch and 110 vlan is allowed on it. SW-10#sh int trunkPort Mode Encapsulation Status Native vlanFa0/24 on 802.1q trunking 4Gi0/1 on 802.1q trunking 2Gi0/2 on 802.1q trunking 4Port Vlans allowed on trunkFa0/24 1...
