Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, currently I have a working DMVPN setup between my HQ and BRANCH office, on my branch side we are running Cisco CME for VoIP communications and my ultimate goal is to reach call manager from head office to connect phones. Currently I am experie...
Hello, currently I deployed a DMVPN setup behind NAT with one Hub and one Spoke, my architecture looks like this Hub - > Home router -> Internet <- Home router <- Spoke My goal is to route home router networks between hub and spoke sides. So for exam...
Hello, recently I deployed Cisco 2811 router as CME, I have several phones and computers operating on different vlans (VLAN 10 VOICE 10.111.10.0/24, VLAN 20 DATA 10.111.20.0/24). I created two subinterfaces on the router with dot1q encapsulation and ...
Thank you very much for your time and support, I finally managed to register my phones with CME on remote site. The problem was with the spoke's core router which was not friendly with vlans, so I decided to put a Cisco switch between core router and...
Currently I have configured 4 out of 24 phones and yes, I have added mac addresses of every phone to the CME, so there is no need for auto registration, but, unfortunately, phones, which are written into CME are not registering, although they are con...
I will try to explain as clear as possible, currently communication between Spoke and Hub works perfectly, all subnets reach each other. Static routes are done in two places on both ends:Hubip route 0.0.0.0 0.0.0.0 10.10.0.1
ip route 10.248.100.0 255...
Hello, Giuseppe, Thanks, again, for your help, I will try to play with default-metric settings, but currently I'm pretty fine with static routes configured on both sides, only problem left is VLAN's, first I thought I should route VLAN over DMVPN tun...
