Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It took me a long time to figure out how to login to the embedded access point on my IR829 router using the command 'service-module wlan-ap 0'. Once I figured that out I thought I was ok. I didn't realize initially that it only works under certain ...
I have configured remote access VPNs for AnyConnect using the FMC. It was easy to apply an extended ACL as a VPN filter as the option is simply a drop-down. So how do I accomplish the same thing with a site-to-site VPN tunnel? Do I simply add the ...
I am trying to allow access to a DNS server on a custom port.
object HOST_192.168.2.51_32
description DNS Server
host 192.168.2.51
nat (inside,outside) static interface service udp 53 5353
access-list outside_access_in extended permit udp any HOS...
When an ASA is fresh out of the box, the interfaces do not have any ACLs applied and the firewall enforces the security-levels. Once an ACL is applied, do the security-levels still apply? As an example, if I want to permit RDP from an inside interf...
Does anyone know of a CCXv2 or higher compatible USB Wi-Fi adapter? I need to perform a location based calibration and that requires a CCXv2 or higher compatible Wi-Fi adapter. I am asking for USB because the internal adapter on my Surface Pro is N...
The reason it needs to check routing and policy routing first on in-to-out NAT translations is that there are likely several interfaces it could use to reach the next hop for routing and therefore the exit interface needs to be determined prior to in...
Can I get an update? it's been several months now since you last indicated that a new set of stencils is in the works. How long does something like this typically take?
For the 40 MHz wide channels, you don't need to do anything other than select the channel width. The AP can select a primary and secondary (bonded channel) automatically. You can set them yourself if you want to, but you only set the primary channe...
