About dantejohnson

dantejohnson · 01-24-2011

We are currently almost out of phone numbers from our service provider. We just acquired a a new block of phone numbers from our service provider. I would like to know the configurations necessary to implement these new batch of numbers. I do not the...

dantejohnson · 05-23-2011

http://www.cisco.com/en/US/ts/fn/620/fn62949.htmlThe link above is the correct solution for your problem. Basicly leave it plugged into the switch for about 20 min. Then it should work.

dantejohnson · 01-25-2011

The dial peers we use for (46XX) is as followsDial-peers voice 4444 potstranslation-profile incoming translate-incoming-DIDincoming called-number 41048146..direct-inward-dialport 0/1/0:23I am not to sure if we are using H 323 because I have little to...

dantejohnson · 01-25-2011

Okay. One more question. Would I have to configure any thing for dial peers? We already have a dial peer for (46XX)

dantejohnson · 01-25-2011

It seems that 5002 points to the CUE auto attendant number. I believe this helps a caller if they do not know the exact extension (46XX). Would/Should I configure the new number to this auto attendant number or do I create a new one.

dantejohnson · 01-25-2011

Here is what the configurations are for the current voice translation ruleRouter#: Show Run!!Voice translation-rule 20rule 1 /4104814600/ /5002/rule 2 /^.*\(. . . .\)/ /\1/!!Voice translation-profile translate-incoming-DIDtranslated called 20!!!To co...

Member Since	‎11-04-2010 05:50 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	10

User Statistics

User Activity

Configuring a new range of phone numbers

Re: Cisco IP Phone 7941G

Re: Configuring a new range of phone numbers

Re: Configuring a new range of phone numbers

Re: Configuring a new range of phone numbers

Re: Configuring a new range of phone numbers