Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are currently almost out of phone numbers from our service provider. We just acquired a a new block of phone numbers from our service provider. I would like to know the configurations necessary to implement these new batch of numbers. I do not the...
http://www.cisco.com/en/US/ts/fn/620/fn62949.htmlThe link above is the correct solution for your problem. Basicly leave it plugged into the switch for about 20 min. Then it should work.
The dial peers we use for (46XX) is as followsDial-peers voice 4444 potstranslation-profile incoming translate-incoming-DIDincoming called-number 41048146..direct-inward-dialport 0/1/0:23I am not to sure if we are using H 323 because I have little to...
It seems that 5002 points to the CUE auto attendant number. I believe this helps a caller if they do not know the exact extension (46XX). Would/Should I configure the new number to this auto attendant number or do I create a new one.
Here is what the configurations are for the current voice translation ruleRouter#: Show Run!!Voice translation-rule 20rule 1 /4104814600/ /5002/rule 2 /^.*\(. . . .\)/ /\1/!!Voice translation-profile translate-incoming-DIDtranslated called 20!!!To co...
