Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all
From the documentation "Cisco NDFC Fabric Controller Configuration Guide, Release 12.1.x" it's possible to replace a Switch using the RMA Flow. It is simple if the old and new devices are of the same family with the same number of ports.
If ...
Hi all,I'm struggling to find a validated design for the interconnection of the WLCs in an SD-Access environment (mid-size enterprise) that meets all the requirements of my scenario.I have two C9500-32QC as Border/Control Nodes, and two Edge Nodes C9...
Hi all, I have tried to find out an answer to my question inside the community, but I don't find it. So I create this discussion.It's possible to emulate L2VPN on CML using a IOS-XR? I have tried the sandbox of CML but it doesn't work. I have found t...
Hi mrflorida,
Thank you for the feedback. Ultimately, we solve the problem by simply deleting the old one and replacing it with the new one using POAP process.
Stefano
Hi AnthonyThank you for the suggestion. According to the datasheet the AP scale limit for the 9K family in eWLC mode is 200 AP. This number is close to our deployment scenario, which is why we use 2 external WLCs.Stefano
Hi PabMar,thank you for the answer. Yes, there are two FW (act/stb) connected to the Border Nodes as Fusion routers.Do you think I need another layer of switching to connect the WLCs or I can use the VSW in this scenario?RegardsStefano
