Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'd like to configure a CAP-3602E in order to use with a single element grid antenna, as I have several of them laying around.I assume that when I'm in full 4x4 MIMO mode (all antenna ports enabled), if I have Tx power set at 23dBm, each antenna port...
I have an AIR 3600 that has been flashed with IOS for standalone mode. If I do a reset using the mode button will it revert back to lightweight mode (and thus need a controller?)Thanks.
The datasheet [1] for the 3600 states that max transmit power and max power setting are 23dbm.However, when setting up 2 different devices using the GUI, the highest setting available for 2.4G is 22dbm, and for 5G is only 14dbm. Why the discrepancy?...
I am wanting to connect a single high-gain directional antenna to a 3600. I am having difficulty understanding antenna configuration for the 3600. I have searched this among many other guides: https://www.cisco.com/c/en/us/td/docs/wireless/access_poi...
Will it damage 3502E or 3602E, with the radios turned up to max power, to operate without 1 or more antennas? I tried hunting this up in the FAQ, etc but didn't find anything specific to these models.
Hmm, I only have a very limited understanding of how MIMO works but the way I understand it is that the 4 antenna array is used to provide a beam-forming pattern by heuristically adjusting the phase of the signal at each antenna based on where it mak...
Ahh, great. Looks like actual code you ran, otherwise I'd question if `amform` is a typo.I am wondering, does that just simply enable beamforming, ie, would one have to disable spatial diversity (assuming you can do that) to ensure only beamforming a...
@patoberli wrote:Do you have a -A or -B model? That can also make a difference.By -A or -B you mean regulatory domain?Also your other devices must support that output power, otherwise you have one way communication, or in other words an outage.I unde...
Thanks Aaron, the spreadsheet was helpful.So what I gather from that is that the total output power is the sum of the power at the antenna ports. It would seem that this could be a little misleading in some cases, if one is thinking of the total rad...
