Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,As I have firewall and L3 switches connected in an infrastructure.Cisco FirePOWER is configured with Global OSPF as VRF is not supported.Cisco Switch is configured both Global and VRF OSPF.Before the following hardening is performed, the routi...
Hi all,I am trying to configure OSPF between Cisco FirePower 2130 and Cisco 9300 Switch. Does the FirePower FDM supports OSPF Authentication Message Digest? If yes, how do I configure it?Please adviseThank YouPeter
Hi all,Previously, I have configured OSPF on ASA Firewall and is very similar to Cisco Routers and Switches.However, when I tried to configure OSPF on FirePOWER Firewall, the SmartCLI and FlexConfig looks pretty confusing.How do you relate the follow...
Hi all,While doing some simulation, I encountered some problems.L3 Switch (L3S1) is able to ping to the HSRP IP address and R2 G0/0/1 IP address. However, PC0 is unable to ping to the HSRP IP address and R2 G0/0/1 IP address.Did I missed out any conf...
Hi all,Based on the diagram below, I would like to achieve the following,- When SVR1 (VLAN10) need to communicate with SVR2 (VLAN20), it will have to go through S1 and ASA2- When SVR3 (VLAN10) need to communicate with SVR3 (VLAN20), it will have to g...
Hi Marvin,Do you have any example or picture to configure OSPF Authentication Message Digest and it's key inside the SmartCLI (OSPF or Interface session)?Please adviseThank YouPeter
Hi Marvin, 1. For the interface OSPF parameters, can I leave the parameters as default? 2. If the parameters are default and we have 7 sub-interfaces, can we apply the same template to all the sub-interfaces?Thank YouPeter
Hi Marvin,I just need to do the following command, but using SmartCLI and maybe FlexConfig if required.1. May I know how to do the following using SmartCLI and maybe FlexConfig?router ospf 1 log-adjacency-changes network 192.168.10.0 255.255.255.0 ...
Hi Marvin,I am managing the device locally using Firepower Device Manager (FDM) via the management LAN port. Software version is 6.3.0-83Please adviseThank YouPeter
