09-29-2019 01:24 AM - edited 02-21-2020 09:32 AM
Hi all,
I am trying to configure OSPF between Cisco FirePower 2130 and Cisco 9300 Switch. Does the FirePower FDM supports OSPF Authentication Message Digest? If yes, how do I configure it?
Please advise
Thank You
Peter
Solved! Go to Solution.
09-29-2019 09:20 AM
09-29-2019 06:39 PM
You're welcome. Please rate the reply if it helped.
09-29-2019 05:19 AM
Yes you can configure it in FDM with Smart CLI as of release 6.3 or later.
To configure OSPFv2, you need to create two Smart CLI objects, using the OSPF and the Interface templates. You add the secret key under the interface just as you would on an ASA.
Note that you cannot use the OSPF template to configure OSPFv3 (for IPv6).
09-29-2019 08:40 AM
Hi Marvin,
Do you have any example or picture to configure OSPF Authentication Message Digest and it's key inside the SmartCLI (OSPF or Interface session)?
Please advise
Thank You
Peter
09-29-2019 09:20 AM
Sure - like this:
09-29-2019 06:26 PM
Hi Marvin,
Thank you so much. Greatly appreciated.
Peter
09-29-2019 06:39 PM
You're welcome. Please rate the reply if it helped.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide