Hi All
I trust you are well
I need some help setting a Cisco Room Bar device on our internal network
.We connect the device via the LAN port and try connecting the end point to our laptop /mobile device, its connects for a few seconds the disconnect...
Hi @Nithin Eluvathingal
Trust you are well
We managed to figure out the problem which is relating to our WIPS setup on our WLAN.We have Rogues rules applied from our WLC which is blocking the wireless beacons from the Miracast signal so when disable...
Hi Nithin
Thank you for your response back, can it not be a wireless protocol?
We have tested from a open laptop and no FW rules in place and we see the same error.
Like it connects then drops after a few seconds
