Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi every one, right now i have problem with a bridge 1310g i can't console it at allwhen i did it give blank screentried two different cables and i did use the com port with a different device and it is totally working but no luck with the bridge...
I don't understand what do you mean by normal serial portAnd as i mentioned before i have already tried every speed on the hyperterm and putty with no luck at allAnd i already tested the cable and the converter on another device and worked perfectly ...
no i don't have original cablei use this oneand did use this converter too with normal RJ45 cable without any result but i did use both of them on another device and worked perfectly i have serial port on my PC
i did use putty and same result did also do restart the ap after i have opened the session and no luck how to change RX and TX pin ???and where is those already ?
