Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Since few days, we can establish a connection with the IPS using IME or MSIE (https). We get errorError: getIpLogList : ct-sensorApp.463 not responding, please check system processes - The connect to the specified Io::ClientPipe failedSSH work...
Hello,ASDM and Telnet access are OK. Since a week SSH is not alway working. We have 2 x 5520 (Active / Failover) with one AIP SSM module each. Last week SSH on primary was KO, rebooted --> OK. SSH KO on the secondary.Nothing regarding trafic blocking...
Hello,Last day we applied new SSL Mobile Licence Extension on both 5520 "8.2.(1)11 (Primary and Failover).Before updating. we notices that Module1 (AIP SSM) was out on secondary ASA, failover was in failed mode. We switched off 2nd ASA, removed the A...
Hello,ASDM works well on several PC and SRV, but from a new W7 notebook, impossible to get ASDM running. When launching we are prompted for uid/pwd, if we type wrong pwd, we get info "wrong password", if tyype right pwd, ASDM Launcher window is immed...
Hello,On our Cisco FW, we have opened tcp 80/443 flow for the sites shown below. We found IP adresses doing DNS Lookup. Unfortunately it seems IPs ares different dependeing the time / date we perform DNS lookup. Result, we didn't open enough, Updates...
Hello,I have the sem problem since sveral days, I found the following workaround on our environement. Working since 5hours.Hope it helps.Regards.IDSM-2 Sensor Module - errSystemError -ct-sensorApp.XXX not responding, please check system processes - ...
Hello,When lauching hw-module module 1 reset, first state Init status, afterwards, Unresponsive statusDo you think ASA-SSM-10 is "dead"? Or is it an ASA problem?regards.----FWNAME# sh module 1 detailsGetting details from the Service Module, please wa...
Hello,What's difficult for us to understand is the difference between light or standalone AP in a security point of vue. Is light model and controller better than standalone models regarding intrusion prevention and detection?Any suggestion will be a...
