Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks, I noticed some of wireless client faced DHCP renew issue when I using C9500-48Y-4C as DHCP server, and C9800-40 as wireless controller (Access point is using local mode).During DHCP renew, the wireless client will send the DHCP request pack...
Hi all, I got the issue when DMVPN and GRE tunnel coexist, then NHRP will have issue.For some reason, I need to create GRE tunnel over IPsec first, then I need to migrate to DMVPN with same IPsec configuration.After I enable DMVPN, then I can not rea...
I've setup "AAA and Certificate" for tunnel group and import Root CA into CA certificate on the ASA.I also setup "CertificateStore" as "Machine" and enable "CertificateStoreOverride" on the client profile. According to the debug result, the VPN sessi...
I have two version of AnyConnect client - v3.1 and v4.8, and I notice when I use v3.1 client and it allow local LAN access, it will only configure the routes which is apply by split tunnel (10.0.0.0/8, 172.16.0.0/12, 192.168.0.0/16). But when I use v...
Hi all, I've established AnyConnect service on Cisco ASAv in my lab, and I can establish SSLVPN connection from my mobile phone and the VM with CentOS7. But I would like to establish SSLVPN connection from AWS instance with CentOS7, but it can not es...
The root cause is I have too many VPN profile at local, so AnyConnect didn't choose the correct one.It's working after I delete other VPN profile and keep the necessary one.
I think there may have some misunderstanding on my previous response. I didn't tell AnyConnect that 192.168.100.0/24 is a secure route, and I also didn't configure it in split-tunnel list.I only configure 192.168.0.0/16 in split-tunnel list, and 192....
Hi Cristian, Unfortunately, I use same policy and same device with different Anyconnect client, so the policy is consistent.I also notice this issue on v4.3 and v4.7, so I guess all of Anyconnect client with 4.X version have same issue.I try to enabl...
