Hi, we have a stack of 3 x C2960. All 3 devices are using one normal power supply. For a second power connection a RPS 2300 is used. Looking at the status we see the following situation: SW PID Serial# Status Sys Pwr PoE Pwr Watts
--- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Unavail
2 Built-in Good
3 Built-in Unavail
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 Active CiscoRPS FDO1614XXXX 1
2 Active CiscoRPS FDO1614XXXX 2
3 Active CiscoRPS FDO1614XXXX 3
RPS Name: CiscoRPS
State: Active
PID: PWR-RPS2300
Serial#: FDO161XXXXX
Fan: Good
Temperature: Green
RPS Power Supply A: Present
PID : C3K-PWR-750WAC
Serial# : AZS154XXXXX
System Power : Good
PoE Power : Good
Watts : 300/420 (System/PoE)
RPS Power Supply B: Present
PID : C3K-PWR-750WAC
Serial# : AZS154XXXXX
System Power : Good
PoE Power : Good
Watts : 300/420 (System/PoE)
DCOut State Connected Priority BackingUp WillBackup Portname SW#
----- ------- --------- -------- --------- ---------- --------------- ---
1 Active Yes 6 Yes Yes XXXXX 1
2 Active Yes 6 No No XXXXX 2
3 Active Yes 6 Yes Yes XXXXX 3
4 Active No 6 No No <> -
5 Active No 6 No No <> -
6 Active No 6 No No <> - What does it mean ? Are 2 switches using the RPS as main power device, and one switch the internal power supply ? Or is something defect ? I'm new and just started to configure the monitoring (using icinga2) and saw an error message. Any help is welcome! Bye, Peer
... View more
