Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am facing MR42 running in low power mode problem. Can I use the external 12VDC and keep using PoE at the same time to solve this problem?My client is not using Meraki PoE switch and has already enabled the lldp in the existing Cisco switch.
I would like to know, if I didn't know the end device type, how can I configure the switch port to ensure the port traffic is good?=========================switchport mode trunk? switchport trunk native vlan?switchport nonegotiate? I am just a junior...