About pl03119481

pl03119481 · 07-02-2019

Hello all, I have a Cisco ASA 5510 which I try to connect to SherWeb Performance Cloud.The tunnel did go up and stayed for a day. But through the weekend something happened and it is down.I've run the debug commands, loggings as well as packet-tracer...

pl03119481 · 06-22-2019

Hello guys, I'm trying to set up an IKEv2 Tunnel between my ASA5510 and SherWeb Tunnel, below is their instruction webpage:http://support.sherweb.com/Faqs/Show/how-to-connect-to-performance-cloud-via-virtual-private-networkAt the bottom are the param...

pl03119481 · 07-03-2019

Here's some update. Since the debugger mainly returns error on the auth_exchange stage, I decided to re-do the config and refresh the interface and see what changes, and here comes the really strange result. I had the tunnel session established succe...

pl03119481 · 07-03-2019

Yes, they are as I have a success example right beside me. Despite the tunnel I'm currently trying to build between ASA5510 and SherWeb Performance Cloud, I have an up tunnel between Fortigate 200D and SherWeb Performance Cloud as an example. So I wo...

pl03119481 · 07-02-2019

I do not have control over the other side. However, on my ASA5510, for ikev2 only there is no option of choosing a specific authentication method. But I only input PSKs and left certificate blank. Thus it should work (That's also what I see from samp...

pl03119481 · 06-23-2019

Thanks for the reply,Yes I had the ikev2 enable outside command in place, and I also deleted the crypto map ikev2-map 2 set pre-shared-key command. Yet I still don't see a good change.

pl03119481 · 06-23-2019

Hello,I've changed the key to a very simple string which I can't type error. But the same line of debugging still appears. I then searched ikev2 config examples and deleted crypto map pre-shared-key but the debugging message still isn't changed. I wo...

Member Since	‎06-22-2019 01:43 PM
Date Last Visited	‎09-18-2019 01:01 AM
Posts	9

User Statistics

User Activity

IPsec IKEv2 on ASA5510. Auth_Method doesn't match?

ASA5510 to SherWeb IKEv2 configuration

Re: IPsec IKEv2 on ASA5510. Auth_Method doesn't match?

Re: IPsec IKEv2 on ASA5510. Auth_Method doesn't match?

Re: IPsec IKEv2 on ASA5510. Auth_Method doesn't match?

Re: ASA5510 to SherWeb IKEv2 configuration

Re: ASA5510 to SherWeb IKEv2 configuration