About richard.abeyta

richard.abeyta · 07-03-2019

I have a cat 3850 as core switch. And 1 cat3850 and 1 cat 9300 as access switches. Any client that gets plugged into an access switch I need it to pull an ip via dhcp from the core switch. So, how do you make this happen. I believe I may be missing s...

richard.abeyta · 06-27-2019

After completing the CIMC setup and rebooting server you then get dropped into the Cisco DNA Center Configuration Wizard. I set the cluster and host subnets incorrectly when using the configuration wizard and now I cannot get back to reconfigure thos...

richard.abeyta · 07-04-2019

Okay thanks for the help. I am not in the data center for a few days so I didn't know a way to test my environment. I tried the same setup in packet tracer but dhcp was failing.

richard.abeyta · 07-04-2019

One of the access switches:interface GigabitEthernet1/0/11switchport access vlan 100switchport mode accessspanning-tree portfast!interface GigabitEthernet1/0/12switchport access vlan 200switchport mode accessspanning-tree portfast!interface GigabitEt...

richard.abeyta · 07-04-2019

SVI'sinterface Vlan100description ** SVI to cat3850-1 & cat9300 **ip address 10.10.10.1 255.255.255.0!interface Vlan200description ** SVI to cat3850-1 & cat9300 **ip address 10.20.20.1 255.255.255.0!interface Vlan300description ** SVI to cat3850-1 & ...

richard.abeyta · 07-04-2019

Hello,Thank you all for your help. Below are the dhcp configs for the core switch. "Service DHCP" is enabled. "IP Routing" is enabled on the core switch and the two access switches. These are dummy IP addresses, and the core switch is providing dhcp,...

richard.abeyta · 07-01-2019

Hello,Unfortunately, the kvm console only allows you to reconfigure the interfaces. You are not able to reset all the options that you were originally able to configure during the setup wizard. I do believe the only solution to this problem is gettin...

Member Since	‎06-27-2019 05:13 PM
Date Last Visited	‎04-02-2025 08:10 AM
Posts	7

User Statistics

User Activity

Configure dhcp on core switch

Start the configuration wizard over again

Re: Configure dhcp on core switch

Re: Configure dhcp on core switch

Re: Configure dhcp on core switch

Re: Configure dhcp on core switch

Re: Start the configuration wizard over again