Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,Can somebody clarify my if I put access control rule in AC policy in firepower that allow traffic from A to B does it automatically permit traffic from B to A? I mean, do I need a new rule that will allow opposite direction?for example, l...
Hi everyone,I would like to establish vpn connection between VPN Client 5.0.7 and Cisco ISR4221 router over certificates. This is the fourth day without success, first day i successed establishing vpn connection using username and password but i need...
I have few questions. The situation is: I have Firepower 2110 in the routed mode and I want to connect 2 data switches from the SAME LAN. Because every port on FirePower has to be on different subnet, how to connect those switches? Bridging and Redu...
Hi guys,I would like to know does any of you have experience with Firepower 2110. I found that neither BVI (on routed mode) and redundant interface are not supported on this device. So, what the replacement would be? How to enable redundancy?Thanks i...
Thank you so much. My 2 switches are in vLAG (vendor Lenovo). So, is it a good idea to do this: on Firepower from two interfaces to create port-channel and on him to create 2 subinterfaces and connect those 2 switches??
