I am trying to upgrade a router 2811, the flash has 64 mb and currently has a IOS 32 mb, but require update it with a IOS 37 mb.What should I do?, I cannot have the two ios in the flash.
HiWhen I try to copy ios to one flash in router 2801, I receive the message of of insufficient memory, and have the follow out in the next command:Router01#sh flashNo files on device-------------------------------------------------------------------...
Us whenever we connecting Circuits Via frame relay.In this case the carrier us this giving a direct connection through ATM.The configuration that is in the remote site is as follows:interface Serial0/1/0 no ip address encapsulation frame-relay ip rou...
We have to move some services that are in the Router 5, and they are not canchange the IP addresses.The computers that are in the lan of the router 1 and 2, see the networks172.16.18.0/24 and 172.1.1.0/24 through the network segments nat 10.253.18.0/...
I have qos in 4 router cisco connected by metroethernet, and i have one firewall connected in the same metroethernet.The config in router cisco is:policy-map QoS class Trafico-Voz-Out priority 1000 set cos 5 class Signaling-Voz-Out bandwidth 96 ...
Hi leolaohooThe router in which i am working is operative, I try to copy a "ios" and when it went to finish, gave me the message "that had insufficient space". I try to copy a ios and then when you run the command "show flash," tells me "Not f...
Hi giuseppe,Thank you for your correction, i am really 0/214sh atm pvc 0/214Description: N/AATM0/0/0.214: VCD: 14, VPI: 0, VCI: 214VBR-NRT, PeakRate: 128 (302 cps), Average Rate: 128 (302 cps)Burst Cells: 1AAL5-LLC/SNAP, etype:0x0, Flags: 0x40, VC...
