Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am running into an issue using Private Vlans on a Cisco Catalyst 3650 running the latest iOS 12 (Gibraltar) release. I have private vlan setup and promiscuous ports in the primary vlan are able to ping machines outside of their vlan mapping....
Hello,Is it possible in a Private VLAN to have multiple promiscuous ports in the Primary VLAN map to separate Community VLANs? I would like each individual promiscuous port to communicate with only 1 specific Community VLAN and the Isolated VLAN in t...
Is the Q-BRIDGE MIB supported on the Catalyst 3650 running IOS Denali 16.3.6? I don't see it via an snmpwalk and I also don't see it on the Cisco MIB locator page. I found this site with supported MIBs for the 3650 but I am not sure if it is 100% a...
Hello, I am attempting to change the allowed vlans (tagged) on trunk ports via SNMP and have tried to using OIDs in the CICSO-VTP-MIB but have not had any luck. I have only been able to read the VLAN configuration on each port. Is it possible to use...
Hello, I am working on a unique system & switch configuration where there are middle-man workstations that communicate with each other and a community of servers. Each workstation must also be able to communicate with one single isolated workstation/...
Thanks for the quick responses. I was able to finally test this out on real hardware. I am using a Catalyst 3650 switch running iOS XE 16.3. Unfortunately I am still seeing the same issue using the same configuration I have posted in this thread. The...
I ended up finding the OID I needed under the CISCO-VITP-MIBhttp://www.mibdepot.com/cgi-bin/getmib3.cgi?win=mib_a&i=1&n=CISCO-VTP-MIB&r=hp&f=cisco-vtp.mib&v=v2&t=tab&o=vlanTrunkPortVlansEnabled
@Giuseppe Larosa- You are 100% correct. I ended up finding the OID I needed under the CISCO-VITP-MIBhttp://www.mibdepot.com/cgi-bin/getmib3.cgi?win=mib_a&i=1&n=CISCO-VTP-MIB&r=hp&f=cisco-vtp.mib&v=v2&t=tab&o=vlanTrunkPortVlansEnabled Thanks
This is my first experience with SNMP so I was just wondering if you could add a MIB to the SNMP agent running on the switch. Thanks for posting this link but I had reviewed this thread previously and it did not provide me with what I was looking for...
Thanks for the information. I am struggling to get this to work on a Catalyst 3650 switch and get a response back of "no such object available on this agent" when running the commands specified in the link you provided. I believe the commands you sup...
