07-31-2019 01:59 PM - edited 07-31-2019 02:06 PM
Hello,
I am attempting to change the allowed vlans (tagged) on trunk ports via SNMP and have tried to using OIDs in the CICSO-VTP-MIB but have not had any luck. I have only been able to read the VLAN configuration on each port.
Is it possible to use OIDs in this MIB to change the trunk port configuration?
Thanks.
07-31-2019 03:03 PM
Generally i use out of box script to do this task
here is some resource for your requirement, not tried myself, test and advise.
08-02-2019 05:39 AM
Thanks for the information. I am struggling to get this to work on a Catalyst 3650 switch and get a response back of "no such object available on this agent" when running the commands specified in the link you provided. I believe the commands you supplied do work as I am running them successfully on another vendor's switch.
Do you know if the Q-BRIDGE-MIB is supported on the Catalyst 3650? I don't see it via an snmpwalk and I also don't see it on the Cisco MIB locator page. Is it possible to load this MIB onto the switch? Thanks.
08-05-2019 07:31 AM
I ended up finding the OID I needed under the CISCO-VITP-MIB
08-05-2019 08:45 AM
07-13-2021 05:51 AM
Hi Tyler,
Can you please share the sample snmp command that you used to achieve this?
I also want to achieve something like this - https://community.cisco.com/t5/network-management/port-segregation-using-snmp/td-p/4432211
Thanks in advance.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: