Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Introduction:-This is a configuration example for 861W/881W/891W series ISRs. It has 2 vlans, vlan 1 for wired users and vlan 4 for wireless users. Each vlan has its dedicated DHCP pool. Configuration Steps:-Before we could access the AP module, we n...
Introduction:-Example of a repeater AP communicating with a root AP using LEAP with local RADIUS server.Configuration Example:-------------->>>>>>>>>>>>>>>>>>Root AP config <<<<<<<<<<<<<----------------sh runBuilding configuration...Current configur...
IntroductionSolutionReference Introduction Sample configuration example of an 871W ISR Solution This configuration example has 2 vlans, vlan 1 and vlan 2 , each mapped to a different SSID with WPA-PSK security sh runBuilding configuration... Cu...
Hi,WLC port and the switchport will auto negotiate the speed/duplex...You need not hard code speed/duplex on the switchport...You may try resettingthe switchport to defaults and configuring it again..for example,(config)# default interface (config)#i...
interface Dot11Radio1no ip addressno ip route-cache!encryption vlan 101 mode ciphers aes-ccm tkip !ssid Test!antenna gain 0dfs band 3 blockchannel dfsstation-role rootUse only one encryption at a time..For 802.11n rates, aes-ccm needs to be config...
Hi,Have you tried accessing the WLC using console at the time you see the issue?Please paste the output of switchport config from the 3750 port where the WLC is connected? Also make sure that the switchport is set for speed/duplex as auto/auto... al...
