Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I see nothing in the release notes for the ISE Log4j patch for Cisco ISE 2.4-3.0 (https://www.cisco.com/web/software/283802505/159582/README_Hotpatch_CSCwa47133_Log4j2-fix-2.4-3.0.txt) that mentions whether or not applying this patch causes downt...
Summary: Endpoints that are rejected multiple times by ISE will continue to get rejected after you fix their settings (MAB or 802.1X) due to RADIUS suppression settings. Version: ISE 2.2+ Issue: When an endpoint has its authentication attempts reject...
Hello,I have configured some switches for Low Impact mode as such below:interface FastEthernetX/Y switchport access vlan 200 switchport mode access switchport voice vlan 100 ip access-group ACL-LOW-IMPACT-MODE in authentication event fail action next...
When you export endpoints in a CSV file if an endpoint is assigned to a custom identity endpoint group then their "IdentityGroup" column will be blank in the exported CSV. If they are assigned to a "Built-in" group then it will show up in their Ident...
Hello,I'm pretty new to LMS and I have taken over a couple of LMS 3.2.0 standalone servers (two different networks). When I reboot them they tend to be slow coming back up (20-30 min). I"m thinking this may be due to the fact that LMS was reinstalled...
Jason, Is it possible to distribute the software and posture profile outside of using the CPP or redirection? I know we don't have to use redirection after 2.2 but I have yet to see anyone document that this works without using the CPP. I have a clie...
Ahmed, Were you able to install the posture module profile manually in that folder on a computer and it worked without requiring the client to be redirected to the client provisioning portal? I have yet to hear of anyone doing this and I have a clien...
Dustin,
I know this is an old post but it seems to me that your mistake (with the ERS API) is trying to add your filter in the headers instead of in the URI. Here's an example of doing this filter in curl:
curl -k -H 'Accept: application/vnd.com....
