Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have to upgrade an C892SFP-K9. Current version is 15.3(3)M6 with ROM: System Bootstrap, Version 15.2(3r)XC, RELEASE SOFTWARE (fc1).
Will I be able to upgrade directly to 15.8.3(M9)? Do I have to watchout for anything specific? I am not really famil...
I've read the documentation Cisco 4000 Series ISRs Software Configuration Guide, Cisco IOS XE 17 which says "When you upgrade from Cisco IOS XE 3.x to 16.x image, you should first upgrade the rommon release to the 16.7(5r) rommon release. After upgra...
Lately I've been working with 802.1x implementation, and to my knowledge a blackhole vlan is always a security best pratice for unused ports in general, but how about when we have 802.1x configured on a port?
In my setup within ISE, policies are conf...
Does anyone know why Windows Location Services has to be enabled for NAM to work correctly on wired connections?I’m struggling to see how these two are related.
I have a customer who enabled it and it immediately resolved the issue, but I’m honestly ...
Hi,
"next-hop is 10.105.32.70...." - Where do you get the IP from?
Did you show the full route table? I would assume you confuse 10.105.32.x with 10.105.36.x.
Hi Leo,
Thank you for your reply.
Unfortunately, I won’t have access to a unit on my desk, as I’ll be upgrading the router remotely for the customer. Using a console cable likely won’t be an option either.
I noticed that Cisco’s software download p...
