Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have installed E4. The update process ended with "successful". After restarting the switch and entering the ip in the browser I am told to enter the login and password, but after that the screen is empty: no graphic web interface and no text based ...
After going back to version E2 I have tried to update to E3 another time. I have started the update with the web ui. I was told that the update was successful. After restarting the switch, the header of the web ui is not displayed correctly. Here is ...
I have the same issue the second time. I have just tried to install the newest version of the firmware on my 2960L 8TS. It is the version E3. I managed this with the web UI of the Cisco. But something went wrong because the progress window was shown ...
Yes, I can ping the IP adress oft he server:Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.178.26, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/5 ms
