Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I was hoping to get some help with a static nat configuration I am struggling to set up (beginner here).Here is the basic networking configuration (I am using a Stratix 5900 router). interface vlan10
ip address 10.0.0.1 255.255.255.0
interfa...
Hi,This is going to be a beginner level question, however I cannot seem to find the answer anywhere.I have the following (relevant) configuration/status: interface FastEthernet0switchport access vlan 10no ip addressFastEthernet0 is up, line protocol ...
Hi guys, Thanks for your responses, I am actually using a Stratix 5900. By following your steps, specifically the arp steps I have realised the issue. It appears that there is already an arp entry in the switch for the ip assigned to my PC assigned t...
