Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a multipod deployment but Im trying to upgrade a spine switch (N9K-9364C).The upgrade do not start and the gui do not shows any fault. The status colum shows NOT SCHEDULE.I tried many times. Application Policy Infrastructure ControllerVersion...
I ran into an issue where the 3 APIC's were using old passwords but I have not those credentials.I want to upgrade the APIC version from 2.2.2j to 4.4.4i, how do I do the upgrade APICs? Note: I Upgraded the APIC CIMC using the Cisco Host Upgrade Util...
Hi ZiadWas the problem solved?If not, you can set up again Multi Pod, erase all configs and TEP Pool for Pod 2.Erase all configuration from your Spine 201 and Leaf X with setup-clean-config. Before check if the version of your devices are the same.Ch...
The IPN devices must support few specific functionalities:MulticastPIM BIDIRDHCP RelayOSPFIncreased MTULayer 3 sub-interfacesQOS considerationsThe recommendation is to deploy, when possible, switches of the Cisco Nexus® 9200 family or switches of Cis...
I installed APIC image many times and I always choose vKVM for installing the image. It took about 3 - 4 hours every time. In kvm tab, open tools and after STATS, you can see the progress.
Hi Sergiu Yes, I selected "upgrade start time" as "Now.I tried with another options like check and unckeck "Ignore compatibility" but it does not work. Thanks
