Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a network provided from Datacenter.I doubt this design will work but before pointing finger on Datacenter, I want to confirm.Design :[Internet] ---> [Switch] ---> [Cisco ASA] ---> [Server]Firewall : Cisco ASA 7.2 (4)They configured singl...
Hi,I have One Switch 3548 with few vlans configured. Now I bought one more switch and want to do the following :Switch 3548 has One VLan as 880 with network as 10.8.8.0 for ports 1 to 8. Now I added one more switch in the network, configured VLan 880...
I will explain scenario in 2 steps :1. Current Setup :We have T1 line coming from datacenter to our office connected to serial port of 2621 router. Fastethernet0/0(FE0) is connected to 2900 Catalyst switch.Firewall Pix 515E (OS version 8.0) is also ...
I did use a cross over cable.I am getting amber light at New switch and old switch has normal green LED.I think it is by default in access mode.Thanks.
Hi,Yes, I have the url to do the 2nd point :1. In normal scenario, both ISPs should be up and running on different subnets, like for datacenter,10.1.x.x is up and running. For other ISP, 10.10.x.x should be up and running at anytime,so user will be f...
Hi,I do not want to use BGP and also any new hardware isn't there anyway to load balance with my current hardware that PIX 515e and Router 2621 ?Also, if it is not possible at all then here is the 2nd scenario, I would like to go with and I think atl...
