Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been tasked with the project of configing this PIX. I am new but now just a little about the PIX. I can not ping any machines in the DMZ or from the inside or outside. Please helpThis is my config Building configuration...: Saved:PIX Version 6...
Cna someone give some insite into the partial meshing of WAN links. My company is trying to divert traffic from the hub, Most of the traffic will be E-mail and the sorts. We will be doing sub interfaces on the lines and not increasing line speed. We ...
Has anyone had any luck configuring secondary IP's on a FRame Relay P2P. I'm readdressing all our frame Links, but couldn't get this to work. It works fine on leased lines, but not frame relay. I get the meaagae FRAME-RELAY INTERFACE-DLCI command sho...
I'm readdressing WAN links and have run into the problem of the Frame relay p2p is saying it's active with sh fr pvc on both ends and the show int command also. One end is a 3620 the other end is a 1601. All indications say it's active. but the inter...
I'm having a problem with secondary IP addressing, the situation is as follows. 3620 with e1/0 with the primary of 10.56.64.1 255.255.224.0 with the secondary of 10.3.0.1 255.255.0.0 going into a switch (3com I believe) then to the 2600 with the E0 p...
I have this setupin about 30offices right now and am happy with it. Iuse an external DSL modem and pluginto the outside interface. The PIX501willgive you the security you need over the D-link and is well worth the extera mony spent.You do get what yo...
You Can do this using MRTG if you want the total bandwidth and not just the tunnel. http://people.ee.ethz.ch/~oetiker/webtools/mrtg/I use this for my WAN and it has workes fine. I Also use RRDTools for the Database format.http://people.ee.ethz.ch/~oe...
Marcell, The secondary will not be assigned addresses through the IP helper command. So the solution would be put your existing primary on the secondary and the new on the primary. This will server addresses out to the new but not the old. Regards Ja...
Another application is NMIS, It's available on the Cisco centric open source page @ http://cosi-nms.sourceforge.net/ It also has a few more packeages that are free. NMIS should be installed on Solaris or Linux of some sort. RegardsJames
