Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I have a little problem with my ASA 5510 version 8.2(1) with a IAS server RADIUS for strong authentication.I have configured a double authentication for my client to access SSL portal:First authentication: AD serverSecondary authenticatio...
Hi everyone,I have a problem with the update of my ASA to version 8.4. It seemed that all my local traffic to the outside worked fine but the reverse traffic didn't work. I tried to see the new configuration it seemed that the migration configuration...
HI,I have a problem in my WCS the audit status is mismatch for my two controllers. When I see the details of the mismatch, it is said that all my 400 users are "not present in controller".However, I checked directly on my web interface of my controll...
Hi everyone,I've recently installed the localisation appliance MSE and it seems to communicate fine with my Controllers WLC using the NMSP protocol.However, I have a problem with this specific protocol (NMSP), I can see in the loggin on different Hos...
It's on the Radius Server Logs that i've seen that the authentication failed. What is the command CLI or in ASDM to see the log RADIUS on the ASA? By the way my RADIUS server is on VMWARE, do you think that might cause a problem? (maybe when you don...
HI,Ok I get it, I did for my static NAT and I replaced the real IP in the access-list outside_access_in.However what should I do with dynamic NAT as follows, it's translated by the interface outside so what kind of ACL should be added:global (outsid...
It's the RADIUS that failed on the first authentication.My radius and AD servers are in two different aaa-server-group.My RADIUS server has a reactivation mode: depletionDead time: 10 minutesTimeout: 15sRetry intervall: 5sMy RADIUS SERVER:Server port...
Thanks for your return, you got the problem. When you mean REAL IP ADDRESS is this mean that I have to write in the ACL mentionned in the log file, the IP instead of the network object?? Is that correct?Thanks
