About nika.benashvili

nika.benashvili · 08-19-2019

Hello, We have ASA, which had 2 tunnels to different data centers.Before they were working OK, but after I changed the trustpoint and certificate, one of the tunnel is not coming up.I only changed the certificate, with the same CA other sites are wor...

nika.benashvili · 08-23-2019

hello, thanks for the hint, fragmentation was disabled on both ends. we enabled it and now it works. thank you.

nika.benashvili · 08-23-2019

Hello, you can not change privilege 15 settings while you are on privilege 14.try to go to enable mode. Did you set up enable password? enable mode by default is privilege 15.

nika.benashvili · 08-21-2019

Hello, By default show run is privilege level 15 command, but you can change it: Switch#show privilegeCurrent privilege level is 14Switch#show run^% Invalid input detected at '^' marker. From level 15 or enable mode try this command:Switch(config)#pr...

nika.benashvili · 08-20-2019

Hello, thanks for reply, As these debug commands are not available on this version on ASA, I made these debugs:debug crypto ikev2 platform 127debug crypto ikev2 protocol 127debug crypto ipsec 127 and then clear crypto ipsec sa.the output is the next...

Member Since	‎08-19-2019 09:47 AM
Date Last Visited	‎11-05-2019 11:15 PM
Posts	5

User Statistics

User Activity

site 2 site vpn is terminated

Re: site 2 site vpn is terminated

Re: Privilege 14 - no show run command

Re: Privilege 14 - no show run command

Re: site 2 site vpn is terminated