About PhilAngell7132

PhilAngell7132 · 06-20-2024

Hi all,Here is our scenario:We have an MX84 with AnyConnect configured to use the DDNS name of our router. This then forwards the SAML request to our Azure instance to authenticate users. This all works fine. However, we have fairly unreliable intern...

PhilAngell7132 · 03-31-2023

Hi All,I have multiple sites configured using various models of MX routers. At one site (lets call it base site) we have AnyConnect set up and working with the MX and using Azure as the IDP. It works a charm. However, I do not like relying on the int...

PhilAngell7132 · 07-15-2022

I am attempting to enable SSO for Cisco AnyConnect through Meraki using Azure AD as the Ipd.I am following this guide:AnyConnect Azure AD SAML Configuration - Cisco MerakiWhich in step 7 says to set these two values in Azure like this:If my AnyConnec...

Octo-line on hold users can't dial out · 08-20-2019

Hello,I have an octo-line which is connected to a few phones. The users are reporting that if a call comes in and any user put the call on hold then the other people who can use the octo-line can still receive incoming calls but can no longer dial ou...

PhilAngell7132 · 06-27-2019

Hi All,I have setup a client VPN connecting into an MX84 router. For the majority of users this is working absolutely fine. However, one user running windows 7 is experiencing error 741 when trying to connect. This is the error for their computer not...

PhilAngell7132 · 06-20-2024

Hi rhbirkelund,From my experience it simple does not fail over. I cannot say for certain if I have waited the full 10 minutes but even if that is correct it is not a very useful failover as that it too much down time.

PhilAngell7132 · 06-20-2024

Hi Alemabrahao,Thanks for this. I don't need them working at the same time I need it for backup purposes. So should our WAN1 connection fail VPN connections can then be made via the WAN2 interface. Is this possible? I have been in contact with Meraki...

PhilAngell7132 · 03-31-2023

I played around a bit more and figured it out (always the way just after you decide to post on a forum). Basically you have to register each AnyConnect instance as a separate enterprise app in Azure. Under Organisation -> Settings -> Authentication o...

PhilAngell7132 · 07-21-2022

Both PhilipDAth and AaronDo were correct, I needed to test it from outside my MX and I had forgotten to add teh custome port. Thank you both for you help.

PhilAngell7132 · 02-24-2020

@luceroc Unfortunately the short answer is no. I believe it would be possible with another layer 3 device which you could use to essentially split the traffic into what you wanted to go over the auto VPN and what don't want to. I haven't tested this ...

Member Since	‎08-20-2019 04:23 AM
Date Last Visited	‎08-27-2019 06:58 AM
Posts	25
Total Helpful Votes Received	6

User Statistics

User Activity

Setup AnyConnect to use both WAN1 and WAN2

AnyConnect VPN using SAML and Azure as an IDP

Azure AD SSO with AnyConnect issues

Octo-line on hold users can't dial out

Client VPN

Re: Setup AnyConnect to use both WAN1 and WAN2

Re: Setup AnyConnect to use both WAN1 and WAN2

Re: AnyConnect VPN using SAML and Azure as an IDP

Re: Azure AD SSO with AnyConnect issues

Re: Route Specific Traffic over VPN