Hello all,Could you please give me some advice about snmp develop. I have a plan using snmp protocol get "show tech-support" and "show diagbus" output information. But I cannot find out howto get those information from a router.Thanks and best regard...

I had find that Tacacs+ from Cisco Systems using TCP/IP protocol, but I don't know which protocol is used by standard Tacacs.

Who can tell me how long this cable can reach?I want deploy a terminal server to control all my routers and switches. Because there some larger one, for examples GSR and 7513, so I want to know if there are four or five frames, what shall I do?Thanks...

Hello,Our office have a Cisco2611 router with two ethernet, one is inside(one Class C ip network), and the other is outside(three globe ip address). when I type the following command(show ip nat translations verbose), the router seemed halt, I can on...