Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys. I need your help. We have 2 asa, fmc, asdm. Tried to install last software updates (6.2.3), everything went good except one asa. FMC, first ASA updated successfully. But on second asa it doesnt pass readiness check.
Currently it's version is...
Hello everyone!
please help me in problem with SPA504G does this phone supports CDP enhancement for second port disconnect or Proxy EAPoL-Logoff if yes how can i configure it in SIP mode. i have switch SF300-24PP 24-Port 10/100 PoE+ configured to Po...
Hi everyone, need help with router CISCO2951/K9 IOS : boot system flash0:c2951-universalk9-mz.SPA.155-3.M2.bin with telephony service. it is reload itself periodically crash info showing
"Unexpected exception to CPU: vector 1400, PC = 0x9AD2C34 , ...
Ok, I solved this problem. Another question. Now it shows this:
Starting script: 200_pre/001_check_reg.plEntering 001_check_reg.plDevice registration in progress. Cannot continue. at 200_pre/001_check_reg.pl line 15.
From script:
my $regdone = SF:...
-So the upgrade script or attempt needs to be run from secondary ASA module which is still on 6.1.0.6.
Yes, exactly! But how should I run it only on secondary ASA? I get exception error from GUI, that's why i was trying to do it manually from console...
I'm not talking about IOS. See screen below. Can't update that second device to 6.2.3.1 as i've explained many times in posts above.
@yogdhanu The script would check /etc/sf/ims.conf as that's where the firepower module information is stored.@
Ye...
Dear Mr. Yoghdanu,
As I told above, everything is correct. Dont bother about that. Yes, the script is identifying incorrectly, because it compares (BEGIN 000_start/105_check_model_number.sh) version from /etc/sf/ims.conf, which is firepower module...
Ok, I am editing logic of install_update.pl, because it sees official update unsigned. So, check begins and here is some errors from output:
[180507 12:03:12:366] FAILED 000_start/105_check_model_number.sh*******************************************...
