Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having problem to configure my VPN tunnel back to my PIX so I'm trying to use cisco VPN client 3.x through the 837 but I'm able to have only one PC at a time connecting through. Any suggestion how to allow multiple VPN client through.RegardsYves
I'm capturing traffic on my switch port and I'm able to see other workstation data, I do not have any port mirroring setup. I'm expecting to see broadcast traffic but not specific data between other two workstation.I do not see full traffic connectio...
Dear AllI have a problem with my smtp connection through my PIX vers 6.2(2). I found that if an aknowledgement packet is lost before getting to the PIX the retransmission of the packet is not recognise.Below is the debug fixup tcp result.Any ideas wh...
Dear AllI have a DMZ subnet outside my firewall which have all my client router connected to it. I do not have control of these routers. I require to stop these routers to be able to talk to each others. I saw the Isolated Private VlANs feature on so...
Dear allI have just purchaced a Catalyst 2948G_GE-TX switch.Is there a HTTP management software for this switch similar to the 3500 series switches?RegardsYves
GlennThanks for that.I thought so. Would I be better to reduce the PDM version so I can still use it for most of the configs but not worry for the VPN and NAT config.I have another PIX running 6.1 with PDM 1.0. The PDM does not stop working it just l...
Thank you for your reply.This is what I thought we should configure from my research, but I'm using PIX 6.3(3) and try to configure using PDM 3.0(1). I enter similar CLI command and when I try to update the pdm config it comes up with an error and dr...
Ashok.I have a static on my ISDN router with a wait of 250ip route 10.30.41.0 255.255.255.0 10.30.60.10 250The problem is when it is advertised via Eigrp the cost chage to 170 the 250 cost is not reflected.When the ISDN is up I get the following EIGR...
The below ip route is what I expect.But after a while I loose the EIGRP updateonly for this Network and it default to R2-ISDNI just removed the static routeno ip route 10.30.41.0 255.255.255.0 Tunnel10I receive the update from My other AFR router10.3...
topology for R2R2-ISDN#sh ip eigrp topo 10.30.41.0 255.255.255.0IP-EIGRP (AS 300): Topology entry for 10.30.41.0/24 State is Passive, Query origin flag is 1, 1 Successor(s), FD is 257280 Routing Descriptor Blocks: 0.0.0.0, from Rstatic, Send flag ...
