About jonathan.colburn.sastre

jonathan.colburn.sastre · 04-26-2023

Hi All, Hope you are well. I've enabled RADIUS authentication using a Kerio NG511 in order to authenticate the users. I have an Cisco 9800 series and in between both of them, there is a Cisco 9200 Stack. I am attempting to set the user authentication...

jonathan.colburn.sastre · 11-07-2021

Good Morning Everyone, Hope you are well. Currently running the following Firmware: Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.06.00.E RELEASE SOFTWARE (fc3) Our technical support compa...

jonathan.colburn.sastre · 04-26-2023

Hi, As far as I can see, the Kerio is doing NAT from the Kerio to the separate Uplinks. If that was the case, would it show the MAC address of the Kerio or the switch?The Kerio Firewall is showing on all connected devices the MAC address of the 9200 ...

jonathan.colburn.sastre · 04-26-2023

Thank you all. As you say, apparently they are different licensing schemes and I couldn't migrate the old ones to the new Controller.

jonathan.colburn.sastre · 04-20-2023

HI All, I am currently facing the same question, but for the new controllers. We are migrating our controller from the 3504 to the 9800 and upgrading from 2802i to 9115AXE. We did pay for the licenses for the 2802i and now we have paid for the licens...

Member Since	‎09-03-2019 12:51 AM
Date Last Visited	‎09-06-2023 12:27 AM
Posts	5

User Statistics

User Activity

Prevent MAC Addressing Masking

IOS firmware updates (SmartNet required)?

Re: Prevent MAC Addressing Masking

Re: Migrate AP licenses from an old controller to a new controller

Re: Migrate AP licenses from an old controller to a new controller