Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there anyway for a user to request a specific ip when they connect to a pix via pptp.pix 501 + windows 2000 vpn client.If I define a staic ip in the client I get an error along the lines of the "the requested address was rejected by the server" er...
I have run into an issue using VPN on 9X machines.The client is a 98 pc that has been logging onto a NT Domain in the past.When the pc VPN into the pix it fails wih bad username/ passwordI have got windows to create ppplog and windows is prepending ...
Has anyone found issues with the 3.1 client running on win2k pro?It works fine on my laptop. But, at my clients site (they have a NT SBS 4.5 server) as soon as you put the client on the laptop you cannot see the printers shared on the server.Any sugg...
I have been looking at this document "http://www.cisco.com/warp/public/110/dynamicpix.html".It suggests that you can setup a VPN connection that is initiated from one end only due to not knowing one of the ip addresses.I have gone through the config ...
Thansk, I had realised that that was probably possible.I was wondering if anyone had resolved the actual problem rather than changing the vpdn username..
I have come up against this problem too many times.Below is pulled from "http://www.cisco.com/warp/public/471/nat_trans.html".Many-to-one, the most commonly implemented NAT solution, maps several private addresses to one single routable (public) addr...
