Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have an environment with Callmanager Express and several DNs, including 1010 and 1020.We need to apply the following configuration: DN 1010 should forward all incoming calls to DN 1020, EXCEPT calls originating from 1020. Is this possible to ap...
Hi,I have a WS-C3850-24P wireless controller that manages three AIR-CAP1602I-T-K9 access points.The software version of the controller is 03.06.08.E RELEASE SOFTWARE (fc1), IOS cat3k_caa-universalk9.SPA.03.06.08.E.152-2.E8.bin.The APs are connected d...
Hi @Rasika Nayanajith,Thank you so much for your help!We apply the changes you have recommended to WLAN "Group". Follows the output of the show wireless client command.BTCOR01#show wireless client mac-address 0026.5a7e.3f4c detail
Load for five secs...
Hi @Rasika Nayanajith,We performed the tests you recommended and the result was as follows:In the wireless network, from an internal client to an internal server: peak around 10 Mbps.In the wireless network, from an internal client to an external ser...
Hi @Rasika Nayanajith,We perform tests using notebooks and smartphones.In some tests, we came to 20 connected users; in others less than 5. And in other tests, there was only the test device connected. In all cases, the problem was the same.I will pe...
Hi @Karsten Iwen,These APs are only used for Internet connections. They are used for guest access only. There is a corporate WLAN configured, but it's not used. I believe I will not be able to test some access to internal resources. However, the conf...
Hi Flavio,Thanks for your help.I verified that there is a "port_child_policy" policy map:Policy Map port_child_policy
Class non-client-nrt-class
bandwidth remaining ratio 10I researched the "bandwidth remaining ratio" command but couldn't understa...
