Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure BGP based routing between two sites using two ASA 5506Xs. Routing between most of the sites works fine. The one exception is the VPN networks. The subnets are configured using the Client Address Pool setting in the AnyConnect...
Hi all,I am currently trying to sort out (with my ISP) whether or not a particular BGP service is configured (using two ASA5506X) correctly. Currently the following is configured:Currently, from the address 172.16.10.3 I can ping:10.252.0.910.252.0.1...
I have two geographically distinct sites, each with an ASA5506, that I am trying to connect via BGP. Please see the attached diagram belowMy work so far has been succesful. Both ASA's have BGP enabled, and have Established connections to the common A...
Hi there. I have two ASA5506Xs which have started rebooting daily. It appears to have started once I renewed their SSL certificates. However, everything SSL wise appears to be working fine. The two devices are connected by a network tunnel. Thanks
Hi all, I recently renewed some SSL Certs for my ASA5506x devices. I am now getting an error (repeatedly) which claims that the verification of a cert chain is failing. However I cannot for the life of me find the certificate that it is referencing....
Hi Rick,No you've actually understood my issue perfectly, and you're correct that we have NAT extemptions for the AnyConnect traffic. I will remove that NAT rule and give it another go, fingers crossed that will be the solution. Thanks for getting ba...
Hi guys,Yes there are currently VPN Site-to-Site tunnels which are in place to handle inter-office routing. The aim is to replace these with BGP based routing.In terms of the Remote Access VPN, we have both Split and Full Tunnel setups (the user choo...
Hi all, Super frustratingly it ended up being a provider error that took a month to resolve. I really appreciate everyone's help and I learnt a lot during the process if that's at all a reward Cheers,David
Hi again,All good on the misunderstanding, I can see that my post was vague, and it was only after I edited it that it really conveyed what I intended.I have done a tracert as you suggested, with no luck:~>tracert 192.168.170.135
Tracing route to 19...
