Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have stand alone Nexus 7018 switch which is connected with 2 ethernet cables to ESX host (VMware V-Sphere 4).My goal is to create ESX host teaming for load balancing purposes between the N7K to the ESX host.I created Port-channel on the N7K ...
Hi I have VSS running in dev. environment. I get complains about layer 4-7 connectivity issues.In show interface output I see that something is killing the tx/rx load and also creates throttles.1) Are throttles caused by the high tx/rx load?2) Is the...
HiOn our network, we use many c6500 as access layer switches. Every user gets 1GB port. We decided to limit broadcasts on each port to 100 packets per second or so. We tried to do this with storm-control command, but the only option for threshold was...
HiI have a Unix station on Vlan X and Unix-based DHCP server on Vlan Y. The Unix station needs to address the DHCP server (that located on different vlan) with Reverse arp (sending it's MAC in order to get it's pridefined IP address from the server)....
NPE-G2 contains 3 built in Gig ports. NPE-400 doesn't contain any port. This means that after the upgrade you'll have additional 3 Gig ports.All other remainig interface names will remain the same.BR,Timor Sherf
Hi Arber,Show ver display the info from the last boot. It means that last time that that ISR booted he used the IOS image that was located on flash. It doesn't mean that it's still there.I suspect that someone deleted this image form flash. If you re...
I agree that N7K isn't ment to be WAN gateway router, but it seems that in this case he has no choise.In my experience with the Service providers, there should be no problem asking them to set 100Mb speed on the port. Morover, they usually deploy sma...
