Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a AIR-AP1220-IOS-UPGRD and am wondering if there is a upgraded firmware or IOS that gives it the ability to do WPA/WPA2 encryption. We are trying to get PCi compliant and if these AP's can not do that then I will need to buy new ones.Thanks
My entire Network is behind a ASA 5505 appliance. I am not good at all with the command line and use the ASDM to configure the unit. We were having some issues with employees using certain websites so I went into the ASDM and on the Firewall tab I we...
I am setting up a WLAN with 1200 AP's and I have three of them. One I am looking at making the Root AP. and then other 2 will be Repeaters. I have created a SSID on the called "WLAN_Warehouse". On the Repeater I have created two SSID's. One is c...
I am trying to setup some AP 1200 series AP's. One I have set to ROOT and then other is set to Repeater. I have aironet ext. turned on. On the Repeater under the SSID manager I have setup the SSID of the Root AP and down below where the Guest Mode...
I have upgraded my 1200 AP to a 802.11b/g radio and now I am experiencing a lot of drops by my clients. When I was running just my 802.11b radio I had some issues with my clients, but after setting my channel to a particular one instead of "LEAST CO...
How do I tell what radio I have in them from the Web interface? I know I did upgrade the radios years ago to the 802.11G radio. If that is the right radio then when I go to the Security section of the radio I have turned on WEP with TKIP 40bit and AE...
That is exactly what I have done from the ASDm, but I still cannot get to the site. That was why I was wondering if there was one more screen I was missing.
Well I have had my AP set to Channel 8 now for a day and a half and I am getting no drops at all. This is a good thing, but from your prior post you make it sound like channel 8 is a bad channel and shouldn't be used. I am confused as to why my pro...
