Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Morning.I have run into a frustrating issue at a client site, where my wireless speeds appear to be capping out at 200mb.The WAN is 800 up/down, and i am seeing these results, on the wired clients (client -> ms210 -> mx68).22 MR44 AP's throughout the...
I have the exact issue as the below post, albeit with different switches. The WLC side always comes UP/UP.C9800-L-F-K9 ans Switch 3750x, no connect - Cisco CommunityWLC port - Te0/1/0 connected trunk full a-1000 1000BaseSX - Te0/1/0 unassigned YES un...
Hi Alemabrahao, Whilst i appreciate a response, it isn't a client issue, antennae issue, channel saturation or any environmental issue for that matter. I understand that this was my first post, but i am a competent network engineer.Thankyou for the i...
rrudling,Thankyou for the pointer.I see where i have made my mistake.After enabling DTP debug i have realized this nonegotiate auto is not related to DTP at all. Running the command 'speed nonegotiate' on the switchport brought the trunk into life. M...
Hi rrudling, thankyou for the reply.both sides are set to no negotiation auto/ switchport nonegotiate. switchport mode trunk.Even in the 'down/down state' on the 3560-CX, making changes to the interface impacts the Link state of the WLC's Te0/1/0 por...
Sorry to resurrect an old thread, but I have searched high and low for an answer on how to access the WMI wirelessly. For such a simple resolution, I have not found the command 'wireless mgmt-via-wireless' referenced anywhere up until now. Thanks.
