Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a UC540 with the 4fxo and 4fxs ports for a customer. The equipment was bought used so I first had to do a password recovery and then I went ahead and erased the old config because it was not applicable to what I needed confi...
Ok guys sorry for the lag on the reply ... seems I finally got it to load the default config by erasing the nvram, then issuing a copy "defaultconfig.cfg" start ... finally it took and reloaded right up in factory default config and gave me an ip in ...
