Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to use DC power in cisco 4331 router? I found this article where is part about how to "Remove DC Input Power from Cisco 4331 ISR". Thank you for replies.
Hello, I have 4331 with SM-X-ES3-24-P switching module and Im trying to copy running config in and out using TFTP. Everything is fine on router but when I try it from switch it says socket error. Thank you for any advice!!
Hello, Im solving issue for a week now and I read a lots of forums but its still same..Im trying to copy config from TFTP server to my Router which has switch card.I can ping from Pc to Router and Switch aswell. When I connect my PC directly to route...
I tried on trunking ports on router ethInternal1/0/0 and 1/0/1 and trunking ports on switch gig0/17 and gig0/18 ti give them access to vlan 10, so they will have IP but its worked only on one pair of them.. They are supposed to work like connection b...
Thank you so much for this but I have no idea about Linux. Is there any chance to solve problem via SSH or console cable? So I need to assign IP to last ports that are trunking connection between router ( ethinternal 1/0/0,1/0/1) and switch( gig0/25 ...
So here is my switch config.I connect to switch from router by using command hw-module session 1/0. I have vlan 30 on router with IP 10.1.3.1 255.255.255.0 .PC has IP 10.1.3.10 255.255.255.0 which is host IP on TFTPd64 server.Last two ports gig0/25 a...
here is my config of switch... im connected from PC to switch via interface gig0/24 which is in vlan 30. Router has interface vlan 30 IP 10.1.3.1 and PC has 10.1.3.10 which is host on TFTP.Last two port gig0/25 and gig0/26 trunk because of communicat...
