Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to do wired 802.1x on a 2960 switch with jumpcloud as radius server? Aaa authentication on the switch self is working.I have a working active directory configuration, but I would prefer a cloud alternative....Thanks!
Hello,I set up a wired 802.1x configuration. A windows DC/DNS/CA and a DHCP/NPS server authenticate and authorize succesfully a switch port.Unfortunately, no traffic is allowed to pass through the port?!? IP address on the host and Vlan on the switch...
Hello All, I made a wired configuration with windows AD with automatic VLAN assignment on a 2960 switch and router on a stick .THere is one DC /DNS/CA server and another NPS/DHCP server.Switch port authentication and authorization succeeds for the Ho...
Hello, In using 802.1x -Windows AD - Cisco 2960 switch , everything works fine when using PEAP-MSCHAP.When using PEAP-TLS , first authentication succeeds. After two minutes, the switch starts reauthenticating, with failure. Do you have any idea what ...
Actually its solved...I found out that with dot1x authentication an extended acl is installed on the switch. I had to overwrite it and apply to the correct interface...
Hello,I have the same problem in a wired environment. Dot1x authentication and authorization succeeds. Client gets IP from DHCP server and Switch port gets it's correct Vlan from NPS server. Both switch and host know each other (Arp). Still I'm not a...
