Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am wondering after these changes or upgrade from NBN will the Cisco 887 router will keep continue working or not. As you may have already heard, NBN will introduce two new functions to Fibre to the Node (FTTN) and Fibre to the Building (FT...
Hi All,I am having issue with setting up a motion alerts for my MV72 outdoor security cameras. As per my configuration I have a schedule from 5pm to 6am in the morning, if there is any people detection send the motion alerts.Also, I have increased th...
Hi All, I am having a strange issue. After the router gets rebooted the MTU command is appearing on all the physical interfaces as well as on the VLAN on the router. After i remove the MTU manually from the VLAN interface it removed it from all the p...
Hi All,Please help to advise the steps required to configure the Guest SSID.I can do by going in to SD-WAN --> Wireless Settings. But there is no option of Client IP assignment - NAT mode: use Meraki DHCPI do not want Guest to connect to the LAN. Do ...
I was getting lots of false alerts for the movement like spider or moth movement near the camera lense even with the 5s and 75% Hence, Now I have enabled the people detection. So far no false alert.I will monitor further, but I am sure as soon as the...
I have attached two screenshots - One people detection enabled and one people detection is disabled.As you see when I enable the people detection my lots of unwanted alerts get dropped.Is this not the right approach...However, in my case rain or stro...
