Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have ASA 5505 setup at a client site and have just installed a new VoIP system. The phones/telco server are on VLAN200 at 10.20.6.0/24, computers on VLAN1 at 172.20.6.0/24. We need to be able to route traffic from VLAN1 to VLAN 200. I went a...
We have a client who requires a site-to-site IPsec tunnel but will not allow our private IPs across the tunnel:"we do not allow private IP addresses across the tunnel so you will need to translate your source private IP addresses behind publicly rout...
We have a 5510 (8.2) with the following 4 interfaces (security-levels) inside (95), outside(0), dmz(25), and test (95). The dmz network is 10.10.10.0/24 and the outside interface is 40.133.84.69.We have run into a situation where a dmz hosted iRedMa...
Hi, We currently have a few 5505s installed at client sites which are connected via s2s ipsec VPN to our datacenter's 5510. We are using Nagios to monitor the local datacenter and remote client infrastructure (over the VPNs) which has been working ...
If understand you correctly changes should look like this?nat (inside,outside) source static prvt-lan-NET prvt-lan-NET destination static access-list customer-VPN-ACL extended permit ip object object-group customer-NETSThanks for your help!!
Hi Jouni,Unfortunately we had a production outage this weekend thus all our time went towards dealing with that. Will try again this weekend and let you know. Thanks again!--Jon
