Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I need to set up a redundance solution where one ISP uses PPPoE and one static ip adresses. And over there I though of running to tunnels, where I either load balanced or used failover.But the real problem is that everything needs to go through th...
Hi all!I am having some problems with getting the group-url to work. Whatever url i type in my browser I end up using the "DefaultWEBVPNGroup". My config is attached.
After I defined reverse-route remote-peer 85.89.x.x i get this:#sh ip cef vrf KOMASP 172.23.1.0172.23.1.0/32 nexthop 85.89.x.x GigabitEthernet0/0.101And the #sh ip route vrf KOMASP 172.23.1.0Routing Table: KOMASPRouting entry for 172.23.1.0/32 Know...
Great article, but I am having some problems. The VPN tunnel is up i see the decaps packets come all the way to the computer behind the IVRF and the reply going from the computer(did some sniffing), but I never see the packets go back throught the tu...
Hi thanks for the reply I justed tried to set a default route through a tunnel in a lab.The tunnel came up, but when it found out that there was an overlapping route it whent down again. So the conclusion is that you can not use a default route thr...
